detroit diesel series 60 jake brake torque specs

Adjust the intake and exhaust valve clearances and injector height.Care should be taken to identify and return assemblies to the proper location if both overhead assemblies were removed. The outboard end of each rocker shaft assembly is marked with the DDC logo for identification. Note: Front and rear rocker shaft assemblies look identical but are not interchangeable due to different bolt-hole center distances. After locating the injector, press down on the top of the injector body with the heel of your hand to seat it in the injector tube. Visually align the injector body for equal clearance between valve springs (there is no locating dowel pin on the underside of the EUI). Insert the injector into its respective injector tube bore.Apply a thin coat of clean ethylene glycol to the injector seal rings and install them in the injector nut ring grooves.Check to make sure the injector bore is thoroughly clean.Place the auxiliary seal in the injector hole and seat it against the top of the injector tube with a 41.3 mm (1-5/8 in.) diameter wood or plastic dowel. This seal should be used in situations where injector tube seal leakage or deterioration is suspected or confirmed. Detroit Diesel encourages the use of an additional service seal (5104701) that is impervious to both coolant and fuel.Failure to replace seals can result in seal leakage.‪ Any time an injector is removed, all three injector nut O-ring seals must be replaced with new seals. Injector seals are considered one-use items and cannot be reused. Permits continuous fuel flow for component cooling.

Atomizes the fuel for mixing with the air in the combustion chamber.Meters and injects the exact amount of fuel required to handle the load.Creates the high-fuel pressure required for efficient injection.The ECM sends a command pulse which activates the injector solenoid. Dodge Viper Wikipedia.The amount of fuel injected and the beginning of injection timing is determined by the ECM. Top Head Rigs Drill Rigs For Sale And Vessels For Sale. RV Smackdown Diesel Vs Gas Gone With The Wynns. 2018 Ford F 150 All Power Specs Announced 5 0L Coyote. Detroit Series 60 Jake Brake Torque Specs CAT C7 Specs And Engine History Capital Reman Exchange.

Camshaft timing, valve lash, injector height, and Jake Brake® lash are all very important specifications that must be followed closely in order to optimize the performance and service life of any Detroit Diesel engine. Specifications for 1988-2007 Detroit Diesel 60-Series diesel engines.

Need torque specs on jake brake bolts al read more. Also would like to know clearances so I can tune it up while valve cover is off. I am looking for torque specs, I have a series 60 and just changed a injector.

Detroit diesel series 60 jake brake torque specs